6011 Drum DRUM: Servo amp fault All Drum init will not clear this fault latch on older firmware (< drum module 1.15) Reset the machine, if the fault does not go away, power off the machine and start up again. If the fault is reported again after the machine is initialised, type <drum init> at the monitor. If it still reports an error you should call Creo service. It may help to leave the machine off for 20 minutes if the fault was caused by high temperature. Digital output from Automotion drum amp, latched in drum amp hardware. see Technical library/<product>/troubleshooting/main drive amp. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:25 2008 PST http://techplanet.creo.com/output/computer_to_plate/vlf_trendsetter/content/troubleshooting/6011.htmOther: Troubleshooting information